TM 9-2350-238-20- 2
2-27. CLEANING (CONT) .
5
6
7
8
Do not use solvent to clean rubber parts. Clean rubber parts by washing with mild solutio n
of soap and water .
Dry parts by blowing with low-pressure compressed air or wiping with clean, lint-free cloths
(item 8, appx C) .
Bearings should be cleaned by procedures in TM 9-214 .
Spot paint metal surfaces after repairs, as required. Sand damaged areas, clean with sol-
vent, and rinse with water. Surface must be clean and dry. Paint with CARC to match ex-
isting color, refer to TM 43-0139 .
2-28. LUBRICATION.
Keep a light coat of lubricating oil (CLP) (item 5, appx C) on parts during repair
procedures to prevent rusting. Lubricate parts during repair and assembly as required. Refer to page 2-8.
2-29. PAINTING INSTRUCTIONS.
Complete painting is authorized for and done by genera l
support maintenance personnel or higher. Spot painting and restenciling vehicle markings is don e
by unit maintenance personnel. Instructions for material preparation, priming, and finish ar e
given in TM 43-0139 .
2-30. NONSKID AREAS .
Nonslip paint (item 15, appx C) will be used to coat deck areas where personnel walk. The areas
to be coated with nonslip paint are shown shaded in the above illustration and on page 2-77 .
2-7 6
Change 1