TM-9-2350-238-34-1

HULL AND RELATED COMPONENTS, RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

MARCH 1994

TM-9-2350-238-34-1 - Page 136 of 292

CAUTION

TM 9-2350-238-34-1

2-42. MAINTENANCE OF AUXILIARY DRIVE ASSEMBLY (GENERATOR DRIVE) (CONT) .

REASSEMBLY (CONT )

If either bevel gear set spiral pinion

gear or bevel gear set spiral gear is

replaced, replace both gears as a

matched set .

9

If removed, press bevel gear set spira l

gear (12) onto gear set shouldered shaft

(13) until seated. Do not disassembl e

after initial reassembly.

10

Using bearing cone inserter, install tw o

tapered roller bearings (14) on gear set

shouldered shaft (13) .

11

Using bearing cup replacer (item 14, appx

E), install two tapered roller bearing cups

(15) into shaft bearing housing (16) and

drive gear bearing housing (17).

2-12 4