TM-9-2350-238-34-1

HULL AND RELATED COMPONENTS, RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

MARCH 1994

TM-9-2350-238-34-1 - Page 127 of 292

TM 9-2350-238-34-1

1 1

1 2

1 3

1 4

1 5

1 6

1 7

Using drift, install inner bearing ring (13)

on clutch shouldered shaft (14).

Install clutch shouldered shaft (14) into

drive shaft housing (11). Ensure tha t

splines do not damage needle roller

bearing and that lip of inner seal is worked

over edge of clutch shouldered shaft and

points inward evenly .

Install new Iockwasher (15) and socket

head capscrew (16) in drive shaft housing

(11) .

Install new gasket (17) on drive shaft

housing (11) .

Mate splines and insert clutch shouldere d

shaft (14) through output drive gear

mechanical housing (4) ,

Seat output drive gear mechanical housin g

(4) on drive shaft housing (11) and gasket

(17), and secure with eight hexagon hea d

capscrews (18). Secure hexagon hea d

capscrews with new Iockwire (19) .

Install new retaining ring (20) on end of

clutch shouldered shaft (14) .

2-11 5