TM-9-2350-238-34-1

HULL AND RELATED COMPONENTS, RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

MARCH 1994

  TM-9-2350-238-34-1 - Page 120 of 292

CAUTION
TM 9-2350-238-34-1
2-40. MAINTENANCE OF AUXILIARY DRIVE ASSEMBLY (VEHICULAR DRIVE) (CONT) .
REASSEMBLY (CONT )
1 5
1 6
1 7
1 8
1 9
2 0
A nicked, scratched, or cut seal lip
will leak during operation.
Install fan drive body hub (23) into
mechanical clutch housing (10). Ensur e
lip of seal is worked up and over edge of
magnetic clutch and points inward evenly
around clutch .
Apply a coat of sealing compound or
silicone adhesive sealant to matin g
surfaces of mechanical clutch housing (3)
and mechanical clutch housing (10) .
Install mechanical clutch housing (10) on
mechanical clutch housing (3) by aligning
guide pin on magnetic clutch with hole in
mechanical clutch housing (10). Secur e
with ten hexagon head capscrews (24)
and new Iockwire (25) (item 34, appx B).
Secure receptacle connector (20) with four
socket head capscrews (26) and new
Iockwire (27) (item 32, appx B).
Install two 5.0-psi (34.5-kPa) pressure
relief grease fittings. Pack two new plain
encased seals with grease. Refer to MIL-
G-10924. Remove two pressure relie f
grease fittings and install two pipe plugs
(28) ,
Install lubricant fitting (29).
.
2-10 8


Back to Top