TM-9-2350-238-34-1

HULL AND RELATED COMPONENTS, RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

MARCH 1994

TM-9-2350-238-34-1 - Page 112 of 292

TM 9-2350-238-34-1

2-39. MAINTENANCE OF AUXILIARY DRIVE ASSEMBLY (CONT) .

REASSEMBLY (CONT )

1 6

1 7

1 8

Secure clutch drive (9) to input drive (4)

with four hexagon head capscrews (11) i n

bottom holes. Secure hexagon hea d

capscrews with new Iockwire (12) .

Install input shaft mechanical housing in

input drive mechanical housing (pag e

2-131) .

Partially install two hexagon head cap-

screws (13) in output drive gear housing

(14). Prevent clutch shouldered shaft fro m

turning by placing a bar between

capscrews .

19

Apply antiseize compound to splines an d

mating surfaces of clutch shouldered shaf t

(15), drive shaft housing (16), and inner

bearing ring (17) .

20

Install vehicular drive (18) on clutc h

shouldered shaft (15). Make sure splines

mate properly .

21

Secure vehicular drive (18) to clutc h

shouldered shaft (15) with key washer (19)

and plain round nut (20). Using spanner

wrench, torque nut to 110 to 150 ft-lb (149

to 203 N-m). Bend tangs of key washer

against plain round nut.

22

Lubricate auxiliary drive. Refer to TM 9-

2350-238-10 .

2-10 0