TM-9-2350-238-34-1

HULL AND RELATED COMPONENTS, RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

MARCH 1994

TM-9-2350-238-34-1 - Page 118 of 292

CAUTION

TM 9-2350-238-34-1

2-40. MAINTENANCE OF AUXILIARY DRIVE ASSEMBLY (VEHICULAR DRIVE) (CONT) .

REASSEMBLY (CONT )

5

6

7

8

9

1 0

Pack annular ball bearing (8) with grease.

Install clutch bearing shield (9) and annu-

lar ball bearing into mechanical clutch

housing (10), using clutch bearing replacer

and press .

Install retaining ring (11).

An improperly installed plain encase d

seal will leak during operation.

Lightly lubricate mechanical clutch housin g

seal cavity with grease. Install new plain

encased seal (12), using oil seal inserter.

Ensure lip of seal is toward inside of

housing .

Install retaining plate (13) and secure with

six machine screws (14). Stake eac h

machine screw in place .

Pack annular ball bearing (15) and annular

ball bearing (16) with grease. Plac e

splined end of bottom part of magnetic

clutch (17) down and install annular ball

bearing (16) using bearing replacer an d

press .

Turn bottom part of magnetic clutch (17)

over and install sleeve spacer (18). Pack

space between sleeve spacer (18), annu-

lar ball bearing (16), and bottom part of

magnetic clutch (17) with grease. Instal l

annular ball bearin g

replacer and press .

(15), using bearin g

2-10 6