TM-9-2350-238-34-2

CRANE (CAB) COMPONENTS, RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

APRIL 1992

TM-9-2350-238-34-2 - Page 144 of 327

TM 9-2350-238-34-2

36 Install spool (52) and winch shift rod

drum (5).

NOTE

Refer to page 2-103 for tow winch

installation procedures.

I

ADJUSTMENT

1

2

3

Hydraulic system is under high

pressure. Follow hydraulic system

safety procedures to prevent injury

(TM 9-2350-238-20-2). Wipe up

spilled hydraulic fluid.

Refer to TM 9-4940-468-14 for test setup

and testing procedures.

Connect hydraulic line (1) to inlet port of

winch control cylinder (2).

Back off two hexagon plain nuts (3 and 4)

to end of threads on winch carrier brake

rod (5).

4

5

6

7

Apply and hold 200 psi (1379 kpa)

pressure on winch control cylinder (2).

Tighten hexagon plain nut (3) until all

slack is taken up.

Tighten hexagon plain nut (3) an addi-

tional 1-1/2 turns, and secure hexagon

plain nut (3) in place with hexagon plain

nut (4).

Release hydraulic pressure and remove

hydraulic line from winch control cylinder

(2),

2-131