TM-9-2350-238-34-2

CRANE (CAB) COMPONENTS, RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

APRIL 1992

TM-9-2350-238-34-2 - Page 250 of 327

TM 9-2350-238-34-2

31 Using drift, remove spring pin (69) from

internal gear (70) and release shouldered

shaft (71).

INSPECTION/REPAIR

1 Inspect for broken, damaged, or missing parts.

2 Inspect ball bearings as prescribed in TM 9-214.

3 Traversing hydraulic motor is a repairable assembly. Refer to page 2-247.

4 If internal gear is broken, damaged, or missing, repair is by replacement of next higher

assembly.

5 If any kit component is damaged, replace entire traversing system power unit kit.

6 Repair is by replacement of authorized parts (TM 9-2350-238-24P-2).

REASSEMBLY

1 Using drift and arbor press, install two

roller bearings (1) in each of three gear

clusters (2).

2-237