TM-9-2350-238-34-2

CRANE (CAB) COMPONENTS, RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

APRIL 1992

TM-9-2350-238-34-2 - Page 279 of 327

TM 9-2350-238-34-2

2-50. MAINTENANCE OF CAB ASSEMBLY (CONT).

INSTALLATION (CONT)

4

5

6

Install three alinement pins (4) (fig. 1,

appx C) in threaded holes in turret bear-

ing outer race assembly (5). Alinement

pins should be 120 degrees apart.

Install FRONT marking on turret bearing

(6) toward front centerline of hull.

Hoist cab assembly (2) off wood blocks

and install on hull using alinement pins

(4) as a guide.

NOTE

●

Remove

three

alinement

pins

from turret bearing when install-

ing screws and Iockwashers in

step 7.

●

To install 28 hexagon head

capscrews and Iockwashers in

step 7, turret must be traversed

to make approximately four

capscrews and Iockwashers ac-

cessible at a time.

7 Install 28 new Iockwashers (7) and 28

hexagon head capscrews (8) securing

turret bearing (6) to hull.

2-266