ADJUSTING OPERATOR'S AND MECHANIC'S SEAT
INITIAL SETUP:
Not Applicable
ADJUSTING OPERATOR'S AND MECHANIC'S SEAT
The operator's and mechanic's seat controls are identical in operation. Use the following procedures for either
seat. The mechanic's seat is shown.
1.
Dump seat — Pull lever (Figure 1, Item 3) inward while standing clear.
2.
Move seat forward or backward — Pull lever (Figure 1, Item 2) inward and hold, adjust seat forward/
backward, then release lever.
WARNING
Apply weight to seat while adjusting. If weight is not applied, spring tension of seat may
cause personnel injury.
3.
Seat height — Pull lever (Figure 1, Item 1) upward and hold, adjust seat height, then release lever.
4.
Adjust backrest position — Lift locking lever (Figure 1, Item 4), adjust backrest height, then release
locking lever.
Figure 1.
Adjusting Seat Controls.
END OF TASK
END OF WORK PACKAGE
TM 9-2350-256-10
0035
0035-1/blank