TM-9-2350-256-10

RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1

OPERATOR'S MANUAL

OCTOBER 2014

TM-9-2350-256-10 - Page 377 of 796

CONNECTING CABLES - Continued

NOTE

•

If towing an M1-series tank, always connect tow cables and shackles to upper

towing eyes. Use the highest strength shackles that will fit towing lugs.

•

Tow cables from the towing vehicle to the disabled vehicle must cross to form an

"X" between vehicles. The cable connected to the operator side of the disabled

vehicle must always cross under the cable connected to the mechanic side of the

brake vehicle.

1.

Position M88A1 in front or rear of disabled vehicle, depress brakes, and shift transmission shift selector

(WP 0012) to P position to lock brakes. Shut down main engine (WP 0017).

2.

Install four shackles (Figure 2, Item 1) on ends of tow cables (Figure 2, Item 5).

WARNING

Ensure shackles are securely connected to avoid separation of tow cable from vehicle.

Failure to comply may result in personnel death, injury, and/or damage to equipment.

3.

Connect shackles (Figure 2, Item 1), for towing, to front towing eyes (Figure 2, Item 2) of disabled vehicle,

and rear towing lugs on M88A1. Install four clevis pins (Figure 2, Item 4) and four locking pins

(Figure 2, Item 3). Tow cables should cross when installed properly.

Figure 2.

Connecting Shackles.

TM 9-2350-256-10

0069

0069-3