TM-9-2350-256-10

RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1

OPERATOR'S MANUAL

OCTOBER 2014

TM-9-2350-256-10 - Page 680 of 796

INSTALLATION

NOTE

•

All roadwheels are installed using the same method, except as noted.

•

To install compensating idler roadwheels, perform Steps 1 through 4.

•

To install suspension hub roadwheels, perform Steps 1, and 5 through 7.

1.

Using a wire brush, clean roadwheel mounting studs and hub assembly.

2.

Install roadwheels (Figure 2, Item 8) on compensating idler hub assembly (Figure 2, Item 1) with ten

washers (Figure 2, Item 7) and ten new self-locking nuts (Figure 2, Item 6). Tighten slightly.

3.

Move track (Figure 2, Item 2) on roadwheels (Figure 2, Item 8) and connect track (WP 0106).

4.

Tighten ten self-locking nuts (Figure 2, Item 6) as shown in torque sequence diagram (Figure 2).

5.

Install roadwheels (Figure 2, Item 5) on hub assembly (Figure 2, Item 9) with ten washers (Figure 2, Item 7)

and ten new self-locking nuts (Figure 2, Item 6). Tighten slightly.

WARNING

When driving vehicle on or off lifter, clear the area. Lifter may fly out from under the

vehicle. Failure to comply may result in personnel injury.

6.

Drive vehicle in reverse (WP 0014) to remove roadwheel lifter (Figure 2, Item 3) from track

(Figure 2, Item 2). Remove roadwheel lifter from suspension arm spindle (Figure 2, Item 4).

7.

Tighten ten self-locking nuts (Figure 2, Item 6) as shown on torque sequence diagram (Figure 2).

TM 9-2350-256-10

0115

0115-4