TM-9-2350-256-20-2

RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL VOLUME 2 OF 2

JUNE 2005
TM-9-2350-256-20-2

  TM-9-2350-256-20-2 - Page 657 of 1440

TM 9-2350-256-20-2
0316 00
UNIT MAINTENANCE
RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1
NSN 2350-00-122-6826, EIC AQA
WIRE ROPE ROLLER ACCESS DOOR REPLACEMENT
REMOVAL, INSTALLATION
INITIAL SETUP:
Tools and Special Tools
Tool kit, general mechanic’s (item 59, WP 0490 00)
Materials/Parts
Adhesive (item 2, WP 0489 00)
Eyebolts (2) (item 211, WP 0491 00)
Lockwashers (2) (item 646, WP 0491 00)
Nuts (2) (item 769, WP 0491 00)
Materials/Parts (cont.)
Pin, cotter (item 529, WP 0491 00)
Pins, spring (2) (item 445, WP 0491 00)
Pin, straight (item 273, WP 0491 00)
Seal, rubber (item 47, WP 0491 00)
Washers, flat (2) (item 537, WP 0491 00)
Washer, flat (item 543, WP 0491 00)
Removal
1.
Remove two nuts (1), two lockwashers (2), and two flat washers (3).
2.
Remove two eyebolts (4) by removing spring pin (5) from each hull tab.
3.
Remove wire rope roller access door (6) from hull by removing cotter pin (7), flat washer (8), and straight pin (9).
4.
Remove rubber seal (10) from wire rope roller access door (6).
Installation
1.
Install rubber seal (10) on wire rope roller access door (6) with adhesive.
2.
Install wire rope roller access door (6) with straight pin (9), flat washer (8), and cotter pin (7).
3.
Install two eyebolts (4) and secure each to hull with spring pin (5).
4.
Secure wire rope roller access door (6) to hull with two flat washers (3), two lockwashers (2), and two nuts (1).
END OF WORK PACKAGE
0316 00-1/2 blank


Back to Top