TM-9-2350-260-20-1-2
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9
TM-9-2350-260-20-1-2 - Page 766 of 772
TM 9-2350-260-20-1-2
FAN DRIVE OIL SEAL REPLACEMENT (Sheet 3 of 5)
NOTE
Place housing-on boards before driving out seal.
5.
Using hammer and brass drift, drive out oil seal (G) from housing (E) and throw meal away.
6.
Clean housing (E) with dry cleaning solvent (Hem 54, Appendix D) and rags (Item 65, Appendix D) and remove any
dried adhesive and oil.
INSTALLATION:
1.
Using putty knife, coat sides of replacement oil seal with sealing compound (Item 24, Appendix D).
Use care to
prevent sealing compound from contacting felt part of seal.
2.
Position new oil seal (A) in housing with lip of seal toward gasket surface of oil seal housing (B).
Go on to Sheet 4
TA146910
9-64
Back to Top
