TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 762 of 772

TM 9-2350-260-20-1-2

CENTRIFUGAL FAN HOUSING REPLACEMENT (Sheet 2 of 3)

2.

Remove fan housings (B) from powerplant.

3.

Using 1/2 inch socket, remove ten screws (C)

securing covers (D) to shroud (E).

4.

Remove covers (D) from powerplant.

5.

Using two 9/16 inch wrenches, remove two

screws, washers, and self-locking nuts (F) that

hold housing (G) and mount (H) together.

Throw

self-locking nuts away.

6.

Using 9/16 inch socket, remove four screws (J).

7.

Remove housing (G) and mount (H) from

powerplant.

INSTALLATION:

NOTE

Make sure no foreign matter is

present in fan housing.

1.

Position mount (A) and housing (B) onto

powerplant.

2.

Using two 9/16 inch wrenches, install two screws,

washers, and new self-locking nut (C) securing

mount (A) and housing (B) together.

3.

Using 9/16 inch socket, install four screws (D)

securing mount (A) and housing (B) to engine

shroud.

4.

Using feeler gage, check clearance between tip of

each fan blade and mount (A) and housing (B).

If

clearance is less than 0.062 inch, go to page 9-58,

step 17, for adjustment procedures.

Go on to Sheet 3

TA146906

9-60