TM-9-2350-261-10

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

OPERATOR'S MANUAL

TM-9-2350-261-10 - Page 269 of 761

TM 9-2350-261-10

OPERATE ELECTRONIC EQUIPMENT HEATER — Continued

0037 00

NOTE

On the majority of heater control boxes, the control light comes on dimmed during the start

cycle of the heater. When heater starts the light goes to full brightness.

3.

Hold RUN-OFF-START switch to START until indicator light comes on. Then move switch to RUN, without stopping

in OFF position.

4.

Select high or low heat with HI-LO switch. Heater will always start on low heat no matter where switch is set. It will

go to high after it starts if switch is at HI.

5.

If heater doesn’t start, try again. If it doesn’t start in three tries, troubleshoot heater (WP 0074 00).

TURN HEATER OFF

1.

Move RUN-OFF-START switch to OFF. Heater will continue to operate for a few minutes until fuel is burned. Then it

will shut itself off.

END OF TASK

0037 00-3/4 blank