TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 238 of 1008

TM 9-2350-261-20-2

REPLACE WARNING PANEL LIGHTS — Continued

0251 00

CLEAN, INSPECT, AND REPAIR

1.

Check light bulb. Replace bad light bulb.

2.

Check light assembly. Replace bad light assembly.

INSTALLATION

CAUTION

Make sure circuit leads are connected to correct lights. See wiring diagrams at the end of

this manual.

1.

Install light assembly (1).

a.

Place light assembly (1) on rear of warning light panel. Secure with two new lockwashers (2) and screws (3).

b.

Connect circuit lead (4) to light assembly (1).

2.

Install light bulb (5).

a.

Install light bulb (5) in light assembly (1). Push and turn light bulb clockwise to secure.

b.

Install gasket (6) and lens (7) in light assembly (1). Turn lens clockwise to secure.

FOLLOW-THROUGH STEPS

1.

Turn MASTER SWITCH to ON (see your -10).

2.

Check differential oil high temperature warning light. It should be OFF. It will come on when you ground circuit 328

lead.

3.

Check engine low oil pressure indicator. It should be ON.

4.

Check transmission high oil temperature indicator. It should be OFF. It will come on when you ground circuit lead 327.

5.

Turn MASTER SWITCH to OFF (see your -10).

END OF TASK

0251 00-2