TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 230 of 1008

TM 9-2350-261-20-2

REPLACE SPEEDOMETER CABLE AND ADAPTER — Continued

0248 00

4.

Remove grommet (6) and gasket (10) from cable (15). Discard grommet and gasket.

5.

Straighten four key washers (4). Remove four screws (5), key washers (4), and final drive adapter (2) from final drive.

Discard key washers.

6.

Remove preformed packing (1) from adapter (2). Discard packing.

INSTALLATION

1.

Place new preformed packing (1) on new final drive adapter (2).

2.

Grease speedometer shaft (3) (WP 0120 00).

3.

Place adapter (2) on final drive, and secure with four new key washers (4) and screws (5). Bend keys on washers.

NOTE

Remove clamps and install new cable.

4.

Install new grommet (6) on new cable (7) and route cable through driver’s compartment bulkhead.

5.

Install grommet (6) in bulkhead.

6.

Install slotted washer (8) and flat washer (9) on speedometer cable (7) and final drive adapter (2).

7.

Install speedometer cable (15) with new gasket (10) on speedometer (11).

0248 00-2