TM-9-2350-261-20-2
CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4
TM-9-2350-261-20-2 - Page 37 of 1008
TM 9-2350-261-20-2
REPLACE THERMOSTAT, HOUSING, AND DEAERATION ELBOW — Continued
0200 00
8.
Loosen two clamps (1). Slide hose (2) off the housing (3).
9.
Remove two screws (4), lockwashers (5), and washers (6) securing housing (3) to the engine. Remove housing (3) and
gasket (7). Discard lockwashers and gasket.
10. If hose (2) is damaged, slide off tube (8). Discard hose.
INSTALLATION
1.
If hose (2) was discarded, slide new hose on tube (8). Slide two clamps (1) on hose. Do not tighten.
WARNING
Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These
compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you
dizzy and irritate your eyes and throat.
Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes.
Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves.
2.
Apply sealing compound (WP 0782 00, Item 62) to both sides of new gasket (7). Place gasket on housing (3). Secure
housing (3) on engine with two screws (4), new lockwashers (5), and two washers (6).
3.
Slide hose (2) onto housing (3). Position two clamps (1) on each end of hose, and tighten.
020000-3
Back to Top
