TM-9-2350-261-20-3

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 3 OF 4

TM-9-2350-261-20-3 - Page 575 of 932

TM 9-2350-261-20-3

REPLACE RAMP DOOR HANDLES AND SHAFT — Continued

0569 00

ADJUSTMENT

NOTE

When adjusted properly, door handle will have no end play. Ramp door should be flush with

ramp in the closed position.

1.

Remove handles (1) and (2) from ramp (3). See REMOVAL Steps 2 - 4.

2.

Remove or install washers (4) and (5) on shaft of handle (2) from inside and outside ramp (3) to obtain proper fit.

NOTE

Install washers (4) on inside and washers (5) on outside of ramp up to a maximum of nine at

each position.

3.

Install handles (1) and (2) on ramp. See INSTALLATION Steps 1 - 4.

4.

Repeat steps as needed to obtain proper adjustment.

FOLLOW-THROUGH STEPS

1.

Open and close ramp door to check that ramp door handles are installed properly.

2.

Perform chalk test (WP 0556 00).

END OF TASK

0569 00-3/4 blank