TM-9-2350-261-20-4

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 4 OF 4

TM-9-2350-261-20-4

  TM-9-2350-261-20-4 - Page 609 of 767

TM 9-2350-261-20-4
MAINTENANCE ALLOCATION CHART (MAC)—Continued
0779 00
0779 00-28
EQUIPMENT
REF CODE
MAINTENANCE
LEVEL
NOMENCLATURE
NATIONAL
STOCK NUMBER
TOOL
NUMBER
11
H
INSTALLER BODY, INJECTOR:
USED
W/4940-00-711-1919 INSTALLER
BODY TO INSTALL INJECTOR TUBE
12
H
INSTALLER PILOT, INJECTOR:
USED
W/4940-00-711-1918 INSTALLER
BODY TO INSTALL INJECTOR TUBE
13
H
INSTALLER FLARING DIE,
INJECTOR:
TO FLARE SMALL END OF INJECTOR
TUBE
14
H
REMOVER, CYLINDER LINER
J-22490
15
H
EXPANDER, FRONT OIL SEAL:
USED
TO EXPAND CRANKSHAFT FRONT
OIL SEAL WHEN INSTALLING
ENGINE LOWER FRONT COVER
16
H
EXPANDER, REAR OIL SEAL:
USED
TO EXPAND REAR OIL SEAL
17
F
HOOK, LIFTING:
USED TO LIFT
FLYWHEEL
18
H
STUD, FLYWHEEL ALINING:
USED
TO ALIGN FLYWHEEL HOUSING OR
ENGINE LOWER FRONT COVER
19
H
CLAMP SET, HOLD DOWN
CYLINDER:
USED TO LOCATE
CYLINDER LINES WHEN
INSTALLING PISTONS
5120-00-999-8618 J-21793-01
20
H
COMPRESSOR, PISTON RING:
USED
TO COMPRESS PISTON RINGS WHEN
INSTALLING PISTON IN CYLINDER
LINER
5120-00-901-8651 KM-J-6883-01
21
H
REMOVER AND REPLACER:
USED
TO REMOVE AND REPLACE PISTON
RINGS
22
H
REPLACER, PISTON PIN RETAINERS:
USED TO REPLACE PISTON PIN
RETAINERS


Back to Top