TM-9-2350-261-20-4

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 4 OF 4

TM-9-2350-261-20-4

  TM-9-2350-261-20-4 - Page 615 of 767

TM 9-2350-261-20-4
MAINTENANCE ALLOCATION CHART (MAC)—Continued
0779 00
0779 00-34
EQUIPMENT
REF CODE
MAINTENANCE
LEVEL
NOMENCLATURE
NATIONAL
STOCK NUMBER
TOOL
NUMBER
80
H
REMOVER AND REPLACER, SLEEVE,
SNAP RING:
USED TO REPLACE
RIGHT ANGLE DRIVE HUB BEARING
81
O
REMOVER AND REPLACER:
USED
TO REMOVE RIGHT ANGLE DRIVE
PINION GEAR:
USED W/5120-00-649-
8140 SLEEVE TO REMOVE RIGHT
DRIVE CARRIER AND OUTER
BEARING, AND TO REPLACE RIGHT
ANGLE DRIVE PINION BEARING CAP
OIL SEAL OR DIFFERENTIAL SHAFT
BEARING CAP OIL SEAL; REMOVE
AND REPLACE IDLER AND ROAD
WHEEL ARM HOUSING BEARINGS
AND OIL SEAL
82
O
WRENCH, PLUG:
USED TO REMOVE
AND REPLACE TORSION BAR PLUG
83
O
ADAPTER, MECHANICAL PULLER:
USED W/5120-00-557-3615 PULLER TO
REMOVE TORSION BAR
84
O
PULLER, SLIDE HAMMER TYPE:
USED W/5120-00-322-5953 ADAPTER
TO REMOVE TORSION BAR; AND
W/5120-00-933-8458 TO REMOVE
TRACK PIN
85
O
ADAPTER, PULLER, TO PULL TRACK
PIN:
USED WITH PULLER 5120-00-
557-3615
86
O
REPLACER, OIL SEAL:
USED TO
INSTALL IDLER AND ROAD WHEEL
HUB OIL SEALS
87
O
REPLACER, WHEEL HUB:
USED TO
INSTALL ROAD WHEEL HUB INNER
AND OUTER BEARING CUPS
88
O
GAUGE, SPROCKET WEAR:
USED TO
CHECK DRIVER SPROCKET WEAR,
AND TRACK BUSHING WEAR


Back to Top