TM-9-2350-261-20-4

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 4 OF 4

TM-9-2350-261-20-4 - Page 625 of 767

TM 9-2350-261-20-4

FABRICATED TOOLS — Continued

0781 00

PARTS REQUIRED:

Item

Part Name

Part No.

CAGEC

NSN

Qty

1

Connector

539409-5

96214

5935-00-

098-9135

1

2

Shell

TBD

TBD

TBD

1

3

Pin (Male)

66506-9

00779

5999-01-

083-0891

12

4

Nut

TBD

TBD

TBD

2

5

Screw

TBD

TBD

TBD

2

6

Screw

TBD

TBD

TBD

2

7

Wire (22 AWG)

M22759/16-22-9

81349

6145-01-

042-4622

AR

8

Sealant

TBD

TBD

TBD

AR

NOTES:

1. Install minimum length (1 to 1-1/2 inches each) jumper wires (7) between pins (3), and insert pins into connector

(1) as follows:

2-3

6-21

11-24

15-16

19-23

20-22

2. Leave pins out of positions 1, 4, 5, 7, 8, 9, 10, 12, 13, 14, 17, 18, and 25.

CAUTION

The inverter under test may be damaged if plug connections are not exactly as specified or if wires are shorted to

the shell/other wires. Make sure wires are not pinched by the connector shell.

3. Position two captive screws (6) in the ears of shell (2). Install shell over connector (1) and secure with two screws (5)

and nuts (4).

4. Fill opening at the rear of shell (2) with sealant (8).

5. Purpose of plug is to fault isolate the inverters to determine which one has failed.

0781 00-2