TM-9-2350-261-34

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-261-34 - Page 143 of 785

TM 9-2350-261-34

REMOVE/INSTALL TRANSMISSION — Continued

0016 00

3.

Position transmission on transfer gearcase. Turn transmission drive-shaft until transmission torque converter studs align

with transfer gearcase drive plate holes. Have helper assist.

4.

Apply a thin coat of antiseize compound to cleaned threads of 12 screws (2) and (3).

NOTE

Screws are different sizes. Each screw must be installed in the same place as it was removed.

5.

Align transmission and air box drain can bracket (5) with transfer gearcase. Secure with ten short screws (2), two long

screws (3 ), and w asher s ( 4) . Hav e h e lper (H) a ssi st . T IG H T E N EA C H S

C R E W TO 252 -3 00

LB

-

IN

(2 8- 34 N ·M )

TO R Q UE . U se to rqu e w ren ch. L OO SE N A ND R E T IG H T E N TO 252 -30 0

LB

-

IN

(28-34 N·M) TOR QUE. U se torque

wrench.

6.

Secure converter studs to drive plate with six new locknuts (4). TIGHTEN NUTS TO 37-40 LB-FT (50-54 N·M)

TORQUE. Use torque wrench.

0016 00-10