TM-9-2350-261-34

TM-9-2350-261-34 - Page 20 of 785

TM 9-2350-261-34

HOW TO USE THIS MANUAL (cont)

LOCATIONAL TERMS

If you are working with power unit items, use this point of reference. Think of the locations as if you were standing at the

transmission end of the power unit and facing the flywheel. This rule applies whether the power unit is IN or OUT of the

carrier.

REFERENCES

References within a WP refer to a different manual or to another WP in the same manual. A step in one WP may be a complete

WP someplace else. Below is an example of a reference step from the WP INSTALL ENGINE COOLANT HEATER KIT.

Exam ple: Low er power plant grill

(see your -20).

The tools needed to do the task will be listed in that task.

MATERIALS/PARTS

For all WPs, the following comments apply:

Par ts whi c h a re li st ed

under INITIAL SETUP

w ill b e r e fer red t o as “new ” i n the W P

steps

w hen in st a lled .

Examples are: “locknuts,” “lockwashers,” “cotter pins,” and some “gaskets.”

The terms “front,” “rear,” “left,” and “right” are used to indicate where items are located. THE POINT OF REFERENCE

FOR THESE TERMS IS DIFFERENT FOR CARRIER ITEMS AND POWER UNIT ITEMS. (Carrier items are items which

are not on the power unit. Power unit items are items on the engine or transmission.)

If you are working with carrier items, use this point of reference. Think of the location as if you were sitting in the driver’s

seat looking out the hatch.