TM-9-2350-261-34

TM-9-2350-261-34 - Page 21 of 785

TM 9-2350-261-34

HOW TO USE THIS MANUAL (cont)

These and other new parts are listed under Materials/Parts in the INITIAL SETUP.

GENERAL MAINTENANCE

Cleaning, inspecting, checking for leaks, and similar procedures which apply to most WPs are found in CHAPTER 3,

GENERAL MAINTENANCE PROCEDURES. Use these steps to clean and inspect any part being removed, repaired, or

installed. Special cleaning will be covered in the WP stepS.

HOW TO USE THE REPAIR PARTS AND SPECIAL TOOLS LISTS (RPSTL) WITH THIS MANUAL

The RPSTL TM 9-2350-261-24P gives the National Stock Number (NSN) required to order parts used in the maintenance

WPs. To use the RPSTL to identify and order a part, do the following:

In this manual, turn to the first page of the WP to be performed.

Find Materials/Parts under INITIAL SETUP, and read the part(s) that need replacement. If required, find the illustrated

part in the WP steps.

Go to the RPSTL and find the same illustrated part. That part will have an item number assigned to it. Look this item

number up in the listing for that figure. The NSN can be found in the National Stock Number and Part Number

Index in the back of the RPSTL.

If you inspect an item and find that it is damaged, go to the RPSTL and find the SMR code for the item. If the SMR

code does not authorize you to repair the item, reassemble it and send it to the authorized level of maintenance.