TM-9-2350-261-34

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-261-34 - Page 661 of 785

TM 9-2350-261-34

REPAIR SIGNAL PATCH PANEL BOX A10 (M1068 ONLY) — Continued

0087 00

DISASSEMBLY

1.

Remove 12 screws (19), lockwashers (18), two strips (17), and three jackfields (9) from signal patch panel box (2).

NOTE

Tag all wires/leads before removal, use wiring diagram (page 0087 00-6).

2.

Remove 20 locknuts (15), screws (14), and five connectors J135, J136, J138, J139, and J140 (13) from signal patch

panel box (2). Discard locknuts.

3.

Disconnect wires (16) from five connectors J135, J136, J138, J139, and J140 (13).

4.

Remove screws (11), lockwashers (10), and 156 jacks (8) from three jackfields (9). Discard lockwashers.

5.

Remove two leads (12) from each jack (8).

6.

Remove jamnuts (6), lockwashers (5), and eight connectors (4) from signal patch panel box (2).

7.

Remove wires (7) from eight connectors (4).

8.

If dust caps (1) are damaged, remove rivets (3) and dust caps from signal patch panel box (2).

0087 00-2