TM-9-2350-273-BD

M48/M60 SERIES TANK, COMBAT FULL-TRACKED 105-MM GUN

TECHNICAL MANUAL; OPERATORS, ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; BATTLEFIELD DAMAGE ASSESSMENT AND REPAIR

TM-9-2350-273-BD - Page 186 of 288

TM 9-2350-273-BD

COMMUNICATIONS

SYSTEM

Procedural Steps (Cont'd)

3.

Use another jumper cable of at least 12-gauge wire, and attach both the black and

the green wires in this power cable to the negative side of the power supply. (Point B.)

4.

Install the R-123M onto the MT-1029, and tie down with rope or web sling.

5.

Remove the outer cover on the female end of the UC-273 connector to make it a

male connector and insert it into the antenna connection point located on the right side

of the R-123M immediately below the AHTEHHA sign. Attach the RF cable.

NOTE

o Frequency must be set manually on the MX6707. If

possible use the auxiliary antenna.

o Use the four-conductor wire to hook up either a H- 189

handset or a CVC helmet to the Soviet chest plate.

11-31