TM-9-2350-277-20-2
CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL VOLUME 2 OF 6
TM-9-2350-277-20-2 - Page 73 of 783
TM 9-2350-277-20-2
PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS), INCLUDING
LUBRICATION INSTRUCTIONS — Continued
0155 00
ITEM
NO.
INTERVAL
MAN-
HOUR
ITEM TO BE
CHECKED OR
SERVICED
CREWMEMBER
PROCEDURE
EQUIPMENT
NOT READY/
AVAILABLE
IF:
e.
Every 1500 miles or semi-annually, perform
the following lubrication procedures. See
Lubrication Table (Table 10, page
0155 00-19).
NOTE
When grease fitting will not accept
GAA, notify your supervisor.
1)
Lubricate idler wheel support arm
bearings through fittings. Use grease
gun with GAA on fitting at rear of
support arm until GAA appears at
relief valve.
2)
Lubricate road wheel and idler wheel
hub bearings. Use GAA and grease
gun with flexible adapter. Lubricate
hub through fitting until grease appears
at relief valve.
3)
Lubricate all road wheel support arm
bearings. Use GAA and grease gun
with flexible adapter on fitting until
GAA appears at relief valve. If support
arm has plugs but no fittings, remove
one plug and install fitting. Remove
remaining plug and install relief valve.
Perform lubrication. Remove fitting
and relief valve. Clean and install two
plugs.
4)
Clean fittings with cleaning compound.
Check/lubricate grease fitting points
after washing or fording.
0155 00-53
Change 5
Back to Top
