TM-9-2350-277-20-3

CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL VOLUME 3 OF 6

TM-9-2350-277-20-3 - Page 506 of 941

TM 9-2350-277-20-3

NOTE

The M58 does not use connector on wiring harness in hull opening. On M58, route leads

through opening in hull. Apply adhesive sealant around harness, ﬁlling opening to a depth of

0.5 to 1.5 inches (1.27 to 3.81 cm).

23. Route circuit 21 (12), 22 (13), 24 (14), and 30 (15) leads through connector (16) and out of carrier. Install connector on

rear top of hull. (All except M58.)

NOTE

The M58 does not use connector, bushing, and hardware only adhesive sealant on wiring

harness in hull opening.

24. Install rubber bushing (17) into connector (16). Secure bushing and leads in connector with nut (18) and washer (19).

(All except M58.)

0362 00-27

REPLACE REAR MAIN WIRING HARNESS (M113A3,

M1059A3, AND

M58) — Continued

0362 00

Change 2