TM-9-2350-277-20-3

CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL VOLUME 3 OF 6

TM-9-2350-277-20-3 - Page 513 of 941

TM 9-2350-277-20-3

NOTE

The M58 does not use connector, bushing, and hardware only adhesive sealant on wiring

harness in hull opening.

45. Route circuit 23 (25), 24 (26), and 31 (27) leads through connector (28) out of hull. Install connector on top of hull (from

inside hull). (All except M58.)

NOTE

The M58 does not use connector on wiring harness in hull opening. On M58, route leads

through opening in hull. Apply adhesive sealant around harness, ﬁlling opening to a depth of

0.5 to 1.5 inches (1.27 to 3.81 cm).

46. Install rubber bushing (29) with leads (25), (26), (27) into connector (28). Secure rubber bushing in connector with nut

(30) and washer (31). (All except M58.)

0362 00-34

Change 2

0362 00

REPLACE REAR MAIN WIRING HARNESS (M113A3,

M1059A3, AND

M58) — Continued