TM-9-2350-277-20-4

CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL VOLUME 4 OF 6

TM-9-2350-277-20-4 - Page 127 of 861

TM 9-2350-277-20-4

REPLACE PUSH-PULL CONTROL ASSEMBLY, BRACKET, LINKS, AND PINS

(CABLE-ACTIVATED LOCK) — Continued

0429 00

8.

Turn the steering wheel (7) left and right to insure the locking pin is not interfering with operation.

9.

Measure the locking pin (2) to see if it is ﬂush with the steering wheel housing (4). The locking pin must be ﬂush and

can have only a negative tolerance. It can be a maximum recess of 1/16 inch (1.6 mm). This measurement is maintained

for all positions of the transmission controller except the SL position.

WARNING

With the transmission controller in any range except SL and if the locking pin is protruding

from the steering wheel housing any amount, the steering wheel will not turn properly and

death of personnel or damage of equipment may occur.

10. Loosen two screws (6) and adjust the bracket (3) until the locking pin is ﬂush or maximum 1/16 inch (1.6 mm) recessed.

Tighten two screws (6).

0429 00-14