TM-9-2350-277-34
CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
TM-9-2350-277-34 - Page 350 of 871
TM 9-2350-277-34
REPAIR HOPPER HATCH HINGE (M58 ONLY) — Continued
0049 00
4.
Bend four retaining strips (1) up, and remove rubber seal (2) from hatch (3).
INSTALLATION
NOTE
All weld joints should be metal to metal fit. In no case should weld gap exceed 3/32 inch or one
half the thickness of thinner member, whichever is less.
1.
Clamp or tack weld new hinge (4) or (5) on hatch (3). Make sure hinges are alined and spaced as shown.
0049 00-3
Back to Top
