TM-9-2350-277-34
CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
TM-9-2350-277-34 - Page 398 of 871
TM 9-2350-277-34
REPLACE RAMP ACCESS DOOR AND HINGES (M113A3 ONLY) — Continued
0057 00
INSTALLATION
NOTE
Shims are used as required for alignment and sealing of ramp door.
1.
Install two new shims (7), two hinges (6), and six screws (5) on ramp door (8). TIGHTEN SIX SCREWS TO 151-166
FT-LB (205-225 N
m) TORQUE.
2.
Install two new shims (3), two hinges (2), and six screws (1) on ramp (4). TIGHTEN SIX SCREWS TO 151-166 FT-LB
(205-225 N
m) TORQUE.
3.
Attach ramp door (8) to a suitable lifting device.
NOTE
Edge of door must be flush with ramp weldment within ± 1/8 inch (3 mm) around perimeter
except where noted.
4.
Position ramp door (8) on ramp (4).
0057 00-3
Back to Top
