TM-9-2350-277-34

CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-277-34 - Page 408 of 871

TM 9-2350-277-34

REPAIR DRIVER’S HATCH COVER HINGES — Continued

0060 00

INSTALLATION

1.

Clamp or tack weld new hinge (1), (2), or (3) on hatch cover (4). Check alignment of cover hinges with hinges on hull.

2.

Insert spring shield (5) through hinges (3) or (2). Seat shield in hinge (1).

3.

Make sure hinges are aligned and spaced as shown.

4.

Weld hinge (1), (2), or (3) to hatch cover (4). See TM 9-237. Use electrode type 5356.

5.

Clean the weld area and apply touch-up paint to repaired area. See TM 43-0139.

FOLLOW-THROUGH STEPS

1.

Install driver’s hatch cover (see your -20).

END OF TASK

0060 00-3/4 blank

Change 2