TM-9-2350-277-34

CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-277-34 - Page 433 of 871

TM 9-2350-277-34

REPLACE RAMP HYDRAULIC CYLINDER ANCHOR (M1064A3 ONLY) — Continued

0065 00

2.

Remove headed pin (2). Retain pin.

3.

Remove cylinder (3) from anchor (4).

4.

Remove anchor (4) and all weld material from hull bottom plate. Discard anchor.

MODIFY

1.

Grind weld area level and smooth.

2.

Locate center of ﬁrst hole as shown.

NOTE

Drill all holes straight and at right angles to hull bottom plate.

3.

Drill ﬁrst hole with 7/16 inch (11 mm) diameter drill. Bottom plate is 1-1/8 inches (3 cm) thick. Do not break through.

4.

Tap ﬁrst hole with a 1/2-13UNC tap to a minimum thread depth of 7/8 inch (22 mm).

0065 00-2

Change 1