TM-9-2350-277-34

CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-277-34 - Page 436 of 871

TM 9-2350-277-34

REPLACE RAMP HYDRAULIC CYLINDER ANCHOR (M1064A3 ONLY) — Continued

0065 00

INSTALL

1.

Install new anchor (1) with three new washers (2) and new screws (3).

2.

TIGHTEN SCREWS TO 54-59 LB-FT (73-80 N•m) TORQUE. Use adhesive primer as lubricant on threads and under

screw heads.

3.

Install cylinder (4) on anchor (1) with headed pin (5). Secure with new cotter pin (6).

FOLLOW-THROUGH STEPS

1.

Install mortar turntable and ring gear. See TM 9-1015-232-23&P.

2.

Install mortar in carrier (see your -10).

3.

Start engine (see your -10).

4.

Raise and lock ramp (see your -10).

5.

Stop engine (see your -10).

END OF TASK

0065 00-5/6 blank

Change 1