TM-9-2350-277-34
CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
TM-9-2350-277-34 - Page 485 of 871
TM 9-2350-277-34
INSTALL PERSONNEL HEATER KIT (M113A3, M1059A3, AND M58 ONLY) — Continued
0072 00
INSTALLATION
NOTE
Flareless (compression) fittings are used on the fuel lines. When these fittings are first installed,
a sleeve is crimped on the tube or hose end. Consequently, when tubes or hoses are replaced,
new fitting sleeves are also required.
1.
Remove six screws (1), two cover plates (2), and two gaskets (3) from top of carrier. Discard cover plates and gaskets.
2.
Remove locknut (4) and screw (5) from transverse beam. Discard locknut and screw.
3.
Remove locknut (6) and screw (7) from engine compartment bulkhead. Discard locknut and screw.
4.
Remove four locknuts (8) and screws (9) from engine compartment bulkhead. Retain four locknuts and screws.
0072 00-2
Change 3
Back to Top
