TM 9-2350-277-34
REPAIR/REPLACE COMMANDER’S INTERFACE BRACKET ASSEMBLY,
MFCS, M95 (M1064A3 ONLY) — Continued
0088 01
INSTALLATION
1.
Choose location for commander’s interface bracket assembly on roof of vehicle approximately 25.5 in. (64.8 cm) from
curbside wall and approximately 7.5 in (19.1 cm) from engine compartment wall.
WARNING
Chemical agent resistant coating (CARC) paint contains iso
c
yanate (HDI) which is highly
irritating to skin and respiratory system. High concentractions of HDI can cause itching and
reddening of skin, a burning sensation in throat and nose, and watering eyes. In extreme
concentrations, HDI can cause coughing, shortness of breath, pain during breathing, increased
sputum production, and chest tightness. The following precautions must be taken whenever
using CARC paint:
NEVER weld or cut CARC-painted materials.
DO NOT grind or sand CARC-painted equipment without high-efficiency
air purifying respirators in use.
BE AWARE of CARC paint exposure symptoms, which can occur a few days after intial
exposure. Seek medical help immediately if symptoms are detected.
3.
Remove paint from area marked for welding of top mounting block (2).
4.
Position top mounting block (2) and weld into place. See TC 9-237 and Welding Code 12472301.
008801-3
Change 4
NOTE
If top mounting block is being installed in vehicle for the first time, go to Step 1. If top mounting
block is being replaced, go to Step 4.
2.
Position top mounting block (2) on roof and scribe a square around the mounting block. Remove mounting block.