TM-9-2350-311-34-1
HULL, POWERPLANT, DRIVE CONTROLS, TRACKS, SUSPENSION, AND ASSOCIATED COMPONENTS: HOWITZER, MEDIUM, SELF-PROPELLED, 155MM
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
SEPTEMBER 1994
TM-9-2350-311-34-1 - Page 13 of 352
TM 9-2350-311-34-1
c. Appendixes
Appendix A provides titles of documents and publications referenced throughout this manual.
Appendix B provides a list of the expendable and durable items necessary to perform the direct support and general
support maintenance procedures.
Appendix C provides a tool identification list of common tools necessary to perform the direct support and general
support maintenance procedures.
Appendix D provides an illustrated list of manufactured items.
Appendix E provides wet torque limits for screws and fastener information.
Appendix F provides a list of the mandatory replacement parts necessary to perform the direct support and general
support maintenance procedures.
d. Alphabetical Index
The alphabetical index is located after the last appendix and provides an alphabetical listing of information contained in
this manual.
e. Schematics
There are eight electrical schematics in foldout form located at the end of this manual.
f. DA Form 2028-2
DA Form 2028-2 is used to report errors and to recommend improvements for the tasks in this manual.
g. Metric Conversion Chart
The metric conversion chart converts English measurements to metric equivalents. Measurements in this manual are
provided in both English and metric units.
WARNINGS, CAUTIONS, AND NOTES
Warnings, cautions, and notes are provided throughout this manual:
Warnings are provided where injury may occur to personnel on or near the howitzer.
Cautions are provided where equipment may be damaged, but no injuries to personnel should result.
Notes provide information, but no personnel injury or equipment damage should result.
INITIAL SETUPS
Before starting a task, you must obtain all the tools, supplies, and personnel listed in the initial setup. Be sure to read
the task before performing the maintenance. If any other tasks are referenced, you must go to the initial setup page for
each of those tasks to find out what tools, supplies, and personnel will be needed.
v
Back to Top
