TM-9-2350-311-34-2

TM 9-2350-311-34-2

2-5

FINAL INSPECTION

Final inspection is performed after repair has been completed to ensure that cab, howitzer, cannon mount, elevating sys-

tem, traversing

system, rammer, and all components are in serviceable condition before returning to user. All materiel will

meet performance and serviceability requirements of this section prior to acceptance for delivery.

a. Final Inspection

Check all painted surfaces for conformance to the standards of TM 43-0139.

Ensure that all unpainted surfaces are lightly coated with grease (item 21, Appx B).

Inspect nuts, bolts, screws, pins, and fastening devices for security of installation.

Observe rotating parts in motion to determine if smooth operation without excessive play and/or binding ex-

ists.

Test operation of exterior spring-loaded device to ensure proper spring compression.

Inspect locations of gaskets, seals, wipers, ports, and packings for evidence of leakage.

Inspect hydraulic tubes, fittings, and components for leakage. Exercise hydraulic components

(TM 9-2350-311-10 and TM 9-2350-311-20-2).

Check for proper nitrogen pressure in recuperator, elevating system, and traversing system.

Examine canvas items for tears or deterioration.

Make sure a detailed inspection of repaired systems and components, as described above in the paragraph

on general inspection, has been performed.

Check level of howitzer cannon trunnions and gun travel lock alinement (TM 9-2350-311-20-2).

b. Repair Parts and Equipment

All repair parts and equipment must be complete or requisitions initiated for procurement of damaged, mis-

sing, or unserviceable parts.

c. Lubrication

Lubrication must be complete and in accordance with TM 9-2350-311-10 and TM 9-2350-311-20-2.

2-6 Change 2

TM-9-2350-311-34-2 - Page 68 of 552