TM-9-2350-358-BD
HOWITZER, MEDIUM, SELF-PROPELLED, 155MM; M109A6
TECHNICAL MANUAL; OPERATOR’S, UNIT, AND DIRECT SUPPORT SUPPORT MAINTENANCE
MARCH 1994
TM-9-2350-358-BD - Page 204 of 343
TM 9-2350-358-BD
10-6.
ROADWHEEL ARM HUB, DAMAGED - CONTINUED
Option 3:
Limitations:
Repair may loosen and leak due to heat and/or vibration.
Personnel/Time Required:
•
1 soldier
•
0.2 hour
Materials/Tools:
•
Piece of plastic or tarp (scavenge from available source)
•
Grease (item 34, Appendix C)
•
Tape, duct (item 62, Appendix C)
References:
LO 9-2350-314-12
Procedural Steps:
1.
Pack bearings and hub assembly with grease.
2.
Cut piece of plastic or tarp to fit over end of hub.
3.
Place plastic or tarp over end of hub and secure with tape.
4.
Record the BDAR action taken.
When mission is complete, as soon as practical, repair the equipment/system
using standard maintenance procedures.
SECTION III.
ROADWHEEL ASSEMBLY
10-7.
GENERAL
Wheel assemblies bear entire weight of vehicle at all times.
Damage or loss of any wheel increases the load on remaining
wheels, which will reduce their life and can cause sudden over stress failure.
10-6
Back to Top
