TM-9-2350-358-BD
HOWITZER, MEDIUM, SELF-PROPELLED, 155MM; M109A6
TECHNICAL MANUAL; OPERATOR’S, UNIT, AND DIRECT SUPPORT SUPPORT MAINTENANCE
MARCH 1994
TM-9-2350-358-BD - Page 303 of 343
TM 9-2350-358-BD
APPENDIX B
SPECIAL OR FABRICATED TOOLS
BDAR FIXES SHALL BE USED ONLY IN COMBAT OR FOR TRAINING
AT THE DISCRETION OF THE COMMANDER. (AUTHORIZED
TRAINING FIXES ARE LISTED IN APPENDIX E.) IN EITHER CASE,
DAMAGES SHALL BE REPAIRED BY STANDARD MAINTENANCE
PROCEDURES AS SOON AS PRACTICABLE.
SECTION I.
INTRODUCTION
B1.
SCOPE
This appendix lists fabricated tools recommended for the support of the M109A6 howitzer in a combat environment.
B-2.
GENERAL
The fabricated tools listed in Section II are tools to be used for testing when test equipment is not available.
SECTION II.
FABRICATED TOOLS
Description:
Voltmeter, 18-30 V dc, 5 V dc or less
NOTE
The voltage rating of the bulb should be close to the value of the expected voltage being
measured.
Materials/Tools:
•
Bulb
•
Wire, electrical, length as required, two pieces
•
Solder
•
Soldering iron
Voltmeter Fabrication/Test Procedure:
1.
Solder a wire to center terminal and another wire to case of bulb.
B-1
Back to Top
