TM-9-2510-247-13-P

FIFTH WHEEL TOWING DEVICE MODEL 250M

TECHNICAL MANUAL; OPERATOR’S, UNIT, AND DIRECT SUPPORT MAINTENANCE MANUAL, REPAIR PARTS AND SPECIAL TOOLS LIST

JULY 2004

TM-9-2510-247-13-P - Page 341 of 522

TM 9-2510-247-13&P

0077 00

INSTALLATION

1.

Position winch assembly (6) in bracket (2).

CAUTION

To prevent contamination of hydraulic system, DO NOT remove caps

and/or plugs from hydraulic lines and ports until ready to connect.

2.

Install four screws (3) on winch bracket (2) and winch assembly (4).

3.

Install two elbows (5) on winch motor (6).

4.

Connect both winch hydraulic hoses.

5.

Charge hydraulics (WP 0056 00-5).

6.

BOOM RETRACT to bring boom to upright position.

7.

Install eight screws (1) on winch bracket (2).

Figure 128.

Winch Assembly

CABLE ASSEMBLY REMOVAL

WARNING

If winch cable has to be cut to remove winch assembly, wrap cut end

of cable in tape and secure loose end of cable to prevent it from

swinging free during winch assembly removal. Failure to follow this

warning could result in injury or death to personnel.

CAUTION

To prevent contamination of hydraulic system, cap and/or plug hydraulic

lines and ports after disconnecting lines.

0077 00-3