TM-9-2520-215-34

CROSS-DRIVE TRANSMISSION ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 2005

TM-9-2520-215-34 - Page 357 of 508

TM 9--2520--215--34

TORQUE CONVERTER TURBINE SHAFT ASSEMBLY REPAIR – CONTINUED

0068 00

ASSEMBLY – Continued

6. Install low range sun gear (4), short hub end first, onto torque converter turbine shaft (2). Install new snap ring (3).

NOTE

The three seal rings near center of torque converter turbine shaft are slightly larger in

diameter than the two toward the rear (ungrooved) end of shaft.

7. Install six new hook type seal rings (1) into grooves on torque converter turbine shaft assembly (2).

8. Press pin (10) into torque converter turbine shaft assembly (2) to a depth of 0.26 inches.

07i045ma

3

4

10

1

1

2

1

NOTE

FOLLOW--ON MAINTENANCE:

Install torque converter turbine shaft

assembly (WP 0067 00)

END OF WORK PACKAGE

0068 00--7/8 blank