TM-9-2520-215-34

TM-9-2520-215-34 - Page 347 of 508

TM 9--2520--215--34

INTERMEDIATE RANGE PLANETARY CARRIER ASSEMBLY REPAIR –

CONTINUED

0066 00

3. Install thrust washers (5) at each end of pinion (4). Retain thrust washers (5) with oil soluble grease.

4. Install assembled pinion (4) into intermediate range carrier assembly (1). Align parts carefully with spindle bore in

carrier.

5. Position spindle (2), solid end up, so that lock ball pocket (7) is aligned directly over lock ball pocket in

intermediate range carrier assembly (1). Press spindle (2) into intermediate range carrier assembly (1) until its

lock ball pocket is near intermediate range carrier assembly lock ball pocket.

6. Insert lock ball (3) into spindle pocket (7). Press spindle (2) into intermediate range carrier assembly (1) until

upper end is flush with carrier.

7. Repeat Steps 2 through 6 to assemble three remaining pinions, 66 rollers and 12 thrust washers.

8. Remove intermediate range carrier assembly (1) from press and stake carrier around solid end of spindles (2).

Center punch ten or 12 points approximately 1/16 inch from spindles (2), or use a blunt tool to peen about 30

percent of the circumference of carrier bore against end of spindles (2).

NOTE

FOLLOW--ON MAINTENANCE:

Install intermediate range planetary carrier

assembly (WP 0065 00)

END OF WORK PACKAGE

0066 00--3/4 blank