TM-9-2520-215-34

TM 9--2520--215--34

WARNING

FASTENERS AND ATTACHING HARDWARE HAZARD

Always use the same fastener part number (or equivalent) when replacing fasteners. Do not risk using a fastener

of less quality; do not mix metric and inch (customary) fasteners. Mismatched or incorrect fasteners can result in

damage, malfunction, or injury.

WARNING

COMPRESSED AIR HAZARD

Compressed air used for cleaning purposes will not exceed 30 psi (207 kPa). Use only with effective chip guard-

ing and personal protective equipment (goggles/shield, gloves, etc.).

WARNING

ADHESIVE HAZARDS

Adhesive causes immediate bonding on contact with eyes, skin, or clothing and also gives off harmful vapors. Wear

protective goggles and use it in a well--ventilated area. If adhesive gets in eyes, try to keep eyes open; flush eyes with

water for 15 minutes and get immediate medical attention.

Adhesive sealant MIL--S--46163 can damage your eyes. Wear your safety goggles/glasses when using; avoid contact

with eyes. If sealant contacts eyes, flush eyes with water and get immediate medical attention.

WARNING

Fuel and oil are slippery and can cause falls. To avoid injury, wipe up spilled fuel or oil with rags.

WARNING

Remove rings, bracelets, wristwatches, and neck chains before working around the transmission or other major

components. Jewelry can catch on equipment and cause injury, or may short across an electrical circuit and

cause severe burns or electrical shock.

WARNING

FIRE EXTINGUISHING SYSTEM HAZARDS

Fire bottles can discharge and injure personnel. Insert antirecoil plugs, lock pins, and cotter pins before working on or

near bottles.

can cause frostbite or eye injury. Wear protective clothing and goggles to avoid contact. If CO

contacts hands,

hold hands under armpits or in warm water until warmed. If CO

contacts eyes, flush with large amounts of water and

get medical attention immediately.

TM-9-2520-215-34 - Page 4 of 508