TM-9-2520-215-34
CROSS-DRIVE TRANSMISSION ASSEMBLY
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
DECEMBER 2005
TM-9-2520-215-34 - Page 93 of 508
TM 9--2520--215--34
0018 00--5
GENERAL MAINTENANCE INSTRUCTIONS – CONTINUED
0018 00
VISUAL INSPECTION AND MINOR REPAIR PROCEDURES -- Continued
Threaded Parts
Inspect all threaded parts for stripped or damaged threads and burrs.
NOTE
Chase threads with a used tap or die. A new tap may cut oversize threads, while a new die
may cut undersize threads.
Replace all parts which have stripped threads or damage which cannot be repaired by chasing the threads with a
tap or die of the proper size.
Snap Rings
Replace all snap rings.
Springs
Inspect springs for:
Wear
Distortion
Breaks
Evidence of overheating
Loss of tension or compression
Replace defective springs.
Shafts and Spindles
Inspect shafts and spindles for:
Excessive wear
Bending
Scores
Cracks
Burrs
Obstructed oil passages
Back to Top
