TM-9-2520-215-34

CROSS-DRIVE TRANSMISSION ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 2005

TM-9-2520-215-34 - Page 100 of 508

TM 9--2520--215--34

0020 00--2

DETERMINING NOMINAL SHIMS FOR OUTPUT BEVEL DRIVEN GEAR

BEARING RETAINER – CONTINUED

0020 00

DETERMINING NOMINAL SHIMS FOR OUTPUT BEVEL DRIVEN GEAR BEARING RETAINER – Continued

4. Measure and record dimension indicated by Y on Figure 1. A method of making this measurement is shown.

Note that thickness of parallel bar must be subtracted from measurement obtained by depth micrometer to find Y

dimension.

5. Measure and record dimension indicated by Z on Figure 1. Hold depth micrometer on retainer (4) surface.

4

6. Record dimension indicated by MD on Figure 1. This dimension is etched on output bevel driven gear.