TM-9-2520-215-34

CROSS-DRIVE TRANSMISSION ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 2005

TM-9-2520-215-34 - Page 105 of 508

TM 9--2520--215--34

0021 00--3

ADJUSTING DRIVE SHAFT PRELOAD – CONTINUED

0021 00

ADJUSTING DRIVE SHAFT PRELOAD – Continued

5. Using an inch--pound wrench (item 23, WP 0088 00) and splined wrench (item 19, WP 0088 00), rotate drive shaft

(3) slowly and record torque required to rotate it.

3

6. Gradually retighten spanner nut (2) against right bearing until all endplay is eliminated. Continue tightening

spanner nut until hole in nut which is closest to slot in drive shaft aligns with slot.

2